Time to make a serious upgrade to your skate work bench! Put bearings in and pull bearings out in seconds with ease with the PowerDyne Bearing Press/Puller. 

Need a 7mm pin for 7mm bearings? You can buy a 7mm pin separately that fits into this press easily! Email us to check availability.

Installing or replacing your bearings is a cinch with the PowerDyne Bearing Press/Puller. Just follow the instructions below and you'll be rolling in no time!

To use the puller, start with the handle up and the long pin down (sideways). Then put the wheel on the outside, push the handle down and it pulls the bearing out. Repeat to pull out the other bearing.

To use the press, stand the pin up and put a bearing down on the pin. Next put the wheel with the outside of the wheel (usually the printed side) facing up and put another bearing on the pin. Tip the pin down (sideways) and carefully pull the handle down. You may have to guide the bearings a bit to get started.

Aluminium hub wheels may be a bit trickier than nylon hub or no-hub wheels. Do not use excessive force. A very small amount of silicone oil around the outside of the bearing usually helps ease them into the aluminium hub wheels.

This tool can be screwed firmly in place for maximum efficiency